Glen-L.com

The Boatbuilder Connection
It is currently Sat May 25, 2013 4:24 pm

View unanswered posts | View active topics


Board index » Design » Human Power

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
dock
 Post subject: Sabotina...bow/transom
PostPosted: Mon May 24, 2010 9:15 am 
Offline

Joined: Mon Apr 19, 2010 9:20 pm
Posts: 8
Location: Lake Tapps Wa.
Another dumb question from a novice... If the full size patterns show the inside size of the bow/transom...then the side and bottom frames will have to extent way past the bow/transom piece in order to have any left when the angles are cut...not flush to the outline of the bow/transom as shown on the plan ??????? Or are they glued on flush to the edge as shown and greatly reduced in size after cutting the angle ?????
Thanks...Steve
Top
 Profile  
 
blt
PostPosted: Sat Jul 09, 2011 12:18 pm 
Offline

Joined: Wed Aug 26, 2009 8:34 pm
Posts: 16
Did you call the company about your question? I was kind of wondering the same thing.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Design » Human Power

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group