Page 3 of 9

Re: Building modified Everglade in Australia

Posted: Sat Feb 22, 2014 10:58 pm
by AusDevil
Things seem to move along so fast when building the shell and then seem to slow down when you get into the details of the internal cabinetry.

Re: Building modified Everglade in Australia

Posted: Wed Feb 26, 2014 1:30 am
by AusDevil
Actually made a few changes , didn't like the painted bits, so re-made new cabinet doors and fridge surround.

Re: Building modified Everglade in Australia

Posted: Wed Feb 26, 2014 4:07 am
by jedema
Growing up, my Dad would always tell me that the Devil was in the details. Looks like your doing a fantastic job with those details :)

Re: Building modified Everglade in Australia

Posted: Thu Feb 27, 2014 2:10 am
by AusDevil
jedema wrote:Growing up, my Dad would always tell me that the Devil was in the details. Looks like your doing a fantastic job with those details :)
Thank you jedema , :)

Re: Building modified Everglade in Australia

Posted: Sun Mar 09, 2014 3:43 pm
by AusDevil
Some more trim work, shelf on left for speakers radio & charging station for iGadget's. Some plumbing before kitchen bench goes in.

Re: Building modified Everglade in Australia

Posted: Wed Mar 12, 2014 11:58 pm
by AusDevil
Kitchen bench after seal coat.

Re: Building modified Everglade in Australia

Posted: Thu Mar 13, 2014 4:27 am
by Trackhappy
Looking great! Must be getting close now.

Re: Building modified Everglade in Australia

Posted: Fri Mar 14, 2014 12:02 am
by AusDevil
Trackhappy wrote:Looking great! Must be getting close now.
Thank you, lots to do yet, , pantry & wardrobe doors , shower & toilet cladding/finish plumbing, start wiring 240v & 12v.
Windows, ceiling & vents outside cladding, door, grey water tank plus stuff I can't think of right now :shock:
List goes on, hope to be finished in 8 to 10 months or there about.

Re: Building modified Everglade in Australia

Posted: Sun Mar 16, 2014 4:32 am
by AusDevil
Been busy lately.

Re: Building modified Everglade in Australia

Posted: Wed Mar 19, 2014 2:19 am
by AusDevil
Worked on the fridge trim "again" today, I'm finally happy with it. (edit. 12/08/14 I have changed the cabinet door above the fridge , made it larger and also much lighter, it is removable if I should wish to install a microwave at some later date.An extra AC outlet will be installed below the fridge)

Re: Building modified Everglade in Australia

Posted: Sat Mar 22, 2014 4:23 am
by AusDevil
spent some time with the cutlery draw. (edit 12/08/2014. I have decided to reserve this area for the switch panel and power board, the cutlery will be elsewhere.)

Re: Building modified Everglade in Australia

Posted: Sat Mar 22, 2014 7:24 am
by BillS
Looking Great! Your trim work is impressive!

Re: Building modified Everglade in Australia

Posted: Sat Mar 22, 2014 11:12 pm
by AusDevil
BillS wrote:Looking Great! Your trim work is impressive!

Thank you much appreciated :) , it's more time consuming than using plastic trim extrusions made for the job but I'm not time poor at the moment.

Re: Building modified Everglade in Australia

Posted: Tue Mar 25, 2014 5:36 am
by AusDevil
In the last view days I have made a few changes and moved to slidecamper.com , had some issues some of you may have noticed the images all over the place and in the wrong order, this has now been corrected.
Now back to working on the camper I also wanted to say thank you for all the positive feedback from you guys. :D :D

Re: Building modified Everglade in Australia

Posted: Mon Mar 31, 2014 2:56 am
by AusDevil
Time for some music , ceiling next ....