Rabl Method

Outboard designs up to 14'

Moderator: ttownshaw

Posts: 55
Joined: Tue Jul 22, 2014 10:23 pm
Location: WV

Re: Rabl Method

Postby miyot » Sun Aug 31, 2014 4:58 pm

brad1516 wrote:thanks I was never going to take my chine off because the side planking was already planed and fitted perfectly I just have a sharper v nose and I added onto my chine and shaped it so my btm plywood has a good fastening spot thanks for the advice and the direction to go in. does anyone have any ideas on the transom I am putting a short shaft 35hp 2 stroke on it was going to make it stronger

Build the motor transom well. Should be in your instructions booklet. Mine was on the last page of it. I think that is all you will need.

Return to “Small outboards”

Who is online

Users browsing this forum: No registered users and 7 guests