got prints

Outboard designs up to 14'

Moderator: ttownshaw

dvx216
Posts: 6
Joined: Fri Jan 23, 2015 10:42 am
Location: orrville,ohio

got prints

Postby dvx216 » Sat Feb 07, 2015 12:40 pm

Opened up the plans for the bullet on diner table .Looking over the drawings I could pretty much follow every thing until I started looking at the transom . Boy did that take a while until I got my brain wrapped around that.I'm sure at some point there was smoke coming out of my ears.The whole 3 dimensional lay out thing took me a while but I figured it out.Looks like getting the wood for the build will be close to home .I live in Amish country and have a great lumber store called Keim Lumber in Charm Ohio is only 40 minutes away.

User avatar
Roberta
Posts: 5946
Joined: Tue Jul 31, 2007 5:23 pm
Location: East Troy, Wisconsin

Re: got prints

Postby Roberta » Sat Feb 07, 2015 2:45 pm

Welcome to the world of boat building. Yup!! The transom angles and it's 3D cutting can be confusing. Feel free to ask questions.

Roberta :D
Roberta "Queen of the Boat Builders"
Built Zip "Oliver IV", Super Spartan "Jimmy 70", and Torpedo "The Glen L".


Return to “Small outboards”

Who is online

Users browsing this forum: No registered users and 8 guests