Aqua cat patterns

Designs for inboard or outboard power

Moderator: BruceDow

Post Reply
Kgumby30
Posts: 16
Joined: Fri Jan 03, 2014 9:46 am

Aqua cat patterns

Post by Kgumby30 »

Hello everyone.
I am tracing the patterns onto the 1/4 plywood for the bulkheads. The distance from the center line and the center of the runner have to be the same. But on the plans 3 out of 5 are the same. One is a 1/4 inch longer and one is more than an 1/8 smaller. Should I make them all the same 27.5.
Thanks
Kevin

JimmY
Posts: 991
Joined: Sat Jul 30, 2016 11:08 am
Location: Brighton, MI

Re: Aqua cat patterns

Post by JimmY »

Yes. When blueprints are copied, the paper can stretch depending on which way the paper goes through the machine. Are the different frames printed in different directions? If so, they are probably a bit off. Make any corrections now.
-Jim
Nothing says poor craftsmanship like wrinkles in your duct tape!

Kgumby30
Posts: 16
Joined: Fri Jan 03, 2014 9:46 am

Re: Aqua cat patterns

Post by Kgumby30 »

Thanks Jimmy

Post Reply

Return to “Power Boats”