Glen-L.com

On my 85 Hp Johnson the lift/drop Hyd. Pump motor is "Open". No continuity between any of the wires going to the pump.

Red #12 (power I think)
Brown #12 (two of them, one for up other for down?
Tan #10 (have no idea what that one does)
I can't get the power cord disconnected right now, but maybe I can take the Electric motor off the Pump? Anybody know that?




I wondered why the Start Sol wouldn't work.
Look at the Crack in it. The whole thing broke in half at that Crack.

Hi Thud,

The brushes on the motor may be stuck or corroded. I think the two screws in the end cap will reveal the brushes and also hold the motor body down to the pump. Could take that apart and do a little cleaning. Not sure what wire does what without a diagram.

Roberta

_________________
Roberta
Built Zip "Oliver IV" and Super Spartan "Jimmy 70"

I'm not sure either Roberta, but those two screws are my next step. I'm gonna wait for some more replies first though.

You're not daring enough, Thud!!! I would wait, too if unsure.

Roberta

_________________
Roberta
Built Zip "Oliver IV" and Super Spartan "Jimmy 70"

I dont want the 'things' in there to fly up in my face and land all over the Barn floor. Lost forever among the other lost forever's of prior guess n' by golly's on that dirt floor.

http://www.maxrules.com has a bunch of diagrams for a lot of motors online...didn't look for yours specifically, but I have gotten several off there before...

_________________
Bob
Sea Knight on the water/Malahini in progress

Thanks Bob, I book marked that place for future ref.