Crackerbox conception

[wickedwood61]

I've never seen lift brackets like that before, where did you find them and on what were they used??

Have fun bldg. your CBox, I'm bldg. one also...

Andycap, the lift points came from a 1967 Century Resorter . They are the same as the ones on my 61 Resorter

[wickedwood61]

You may want to revisit your chine/stem junction. It looks way off from your picture.

Good eye lakeracer69. The shear was actually glued 13/16 higher than the photo. Another layer of the breasthook was not in place yet.

[wickedwood61]

Second layer going on. Seems are tight!

[heuben]

Hope mine goes this quickly, looks awesome.

[fergal butler]

Looking good.

[wickedwood61]

Things have been moving along pretty well!

[wickedwood61]

Fiberglass sheeting her now

[wickedwood61]

More

[wickedwood61]

Installed the spray rails and sprayed the first coat of primer today

[BayouBengal]

Looking great!

[Gayle Brantuk]

Very nice!

[Andy Garrett]

Classic white... nice!
Time to flip it!

[wickedwood61]

Well I started back at it a few weeks ago. I built a eng. mockup, drilled prop shaft hole and dialed in the engine location. Made some new engine mount blocks at 14 degrees. Old ones were getting bad. Also finished up the boat dolly for the flip. I will be mounting prop strut on the boat and drilling shaft hole soon. Then its painting the hull and flipping for engine install.

[wickedwood61]

new eng. mounts

[wickedwood61]

Prop shaft hole is drilled. The bit drifted off a little to starboard side but I'm still good to go.