I have made some progress on the Squirt build and decided to post some pics.
Lengthened to 11'6" with a 1993 SeaDoo SP 580cc motor. Progress is slow as I travel with my "real job". I began in April of 2008 and this is where I stand as of October 2008 after returning from the Gathering at Lake Guntersville.
I boogered up the transition joint because I did not read the plans completely and had to do a bit of fairing before fiberglassing.
It is a bit nerve racking cutting a hole in your freshly completed hull!
I begin fairing the hull this weekend. Thanks to everyone at The Gathering 2008 for your advice and encouragement.
About using jet ski motors to power small boats
Moderator: Bill Edmundson
2 posts • Page 1 of 1
Great job... the pics are real clear... I am building the same boat... Just recieved my plans in the mail.... I am using a 800 cc motor and want to stretch the boat aswell... I am a first time builder,, how do you stretch the boat?
Who is online
Users browsing this forum: No registered users and 5 guests