Mast rake for a glenL 14
Moderator: BruceDow
Mast rake for a glenL 14
i purchased an aluminum mast for my GlenL14. I need to cut a block at the proper angle to rake the mast to 4". I am supposed to level the hull. What part of the boat do I put a level on to confirm the hull is level? The sole, the seats, the centerboard trunk? ??
Re: Mast rake for a glenL 14
Im not familiar with the plans. Was there a set up level as you built it called out in the plans? If so i'd use that.
Check out my project and blog! http://fv-escape-hatch.com/project
Re: Mast rake for a glenL 14
Typically, the top of building form is the level line. If this is the case, reference the point on the frames that sat on the building form.
-Jim
Nothing says poor craftsmanship like wrinkles in your duct tape!
Nothing says poor craftsmanship like wrinkles in your duct tape!