Complete!!

A place to celebrate your first launch with video and/or photos

Moderator: ttownshaw

User avatar
dabren
Posts: 89
Joined: Thu Nov 27, 2008 12:56 pm
Location: Vancouver, BC

Complete!!

Postby dabren » Tue Sep 06, 2011 12:31 am

Thanks to everyone who has ever contributed to this forum, especially those who answer direct questions in a quick manner - this forum is a wealth of info and has definitely helped me to get my boat in the water.

Although the fabric to cover the back of the seat and the sides of the interior was not in, I decided to launch it this long weekend since all else was done. I am super happy with the performance!

So all those many, many, many hours, and many, many months were worth it. It floated...and performed great. When I backed the trailer into the water and the boat floated off, all the hard work (especially the sanding) was forgotten.

At first the motor was trimmed up and it was awesome but the lake was very busy so lots of chop and it bounced a bit. No surprise since it is obviously not meant to tackle any rough waters. Today I dropped the trim by one notch and it was all smooth sailing from there. It just cut through all the small waves. Bummer that both my camera and my girlfriend's were dead after only one video today - we wanted to get some more smooth action since all the videos are shot with her just holding the camera.

I think we got a bit more speed when the tilt was up so if it was really calm we'd probably go like mad one notch up and not have to worry about a little bounce. If I had to guess I'd say I got about 40mph since we were smoking all the boats on the lake but I'll need to get a GPS (I couldn't install my speedometer pitot due to the transom cap). I can adjust the engine internally to allow more throttle with the turn of a screw so of course I'll do that next.

Thanks again everyone, your help is greatly appreciated...I'll need it again when I build my next one!!

Dan

PS it's amazing how much attention a home built boat gets, even just people driving by on the highway...really I met a ton of people this weekend just cause of the questions/complements thrown my way.

http://www.youtube.com/watch?v=pLgN7lcLIcc
Last edited by dabren on Wed Jun 24, 2015 7:03 pm, edited 1 time in total.

slug
Posts: 1441
Joined: Sat Sep 22, 2007 9:49 am
Location: Colborne ON Can

Re: Complete!!

Postby slug » Tue Sep 06, 2011 3:14 am

Congratulations Dan! You should be proud of the beautifull results of all that hard labour, It looks great.
Doug

User avatar
jamundsen
Posts: 1494
Joined: Tue May 26, 2009 12:47 pm
Location: Lakeland, Fl
Contact:

Re: Complete!!

Postby jamundsen » Tue Sep 06, 2011 3:44 am

Looks like a lot of fun. Congrats!!
John Amundsen
Monte Carlo
Lakeland,Fl

Work tends to get in the way of boat building

User avatar
fergal butler
Posts: 1292
Joined: Sun Sep 06, 2009 2:55 am
Location: Co.Dublin, Ireland.

Re: Complete!!

Postby fergal butler » Tue Sep 06, 2011 4:13 am

Well done dabren she looks great and with only 72 posts it must have been a breeze for you to build. :D

User avatar
DaveLott
Posts: 3688
Joined: Sat Jul 04, 2009 3:50 pm
Location: Branson, MO
Contact:

Re: Complete!!

Postby DaveLott » Tue Sep 06, 2011 4:15 am

Great Job and looks like you have a fine lake to use it on as well
Dave

Riviera build - the Midnight Cry Project
Glen-L Sea Kayak
Mahalo Standup Paddleboard

Video of Midnight in Action

Few things in the world measure up to the thrill and satisfaction of boating in a boat that you built.

upspirate

Re: Complete!!

Postby upspirate » Tue Sep 06, 2011 4:29 am

Great job....will look at the videos now.

As far as the speedo,they aren't all that accurate,but if you have it installed,you can always make a filler piece to fit above the transom cap to fit the pitot base flange so it will fit to the cap and the filler

upspirate

Re: Complete!!

Postby upspirate » Tue Sep 06, 2011 4:43 am

What motor was it? I can't remember.

When you post again, maybe you can show a pic of the cavitation plate height to the bottom.

Also what pitch prop and RPM as well as GPS speed.

Great job!!! :D

User avatar
Roberta
Posts: 5946
Joined: Tue Jul 31, 2007 5:23 pm
Location: East Troy, Wisconsin

Re: Complete!!

Postby Roberta » Tue Sep 06, 2011 4:54 am

Looks Great, Dan!!!What a beautiful lake to boat on, too.

Roberta :D :D :D :D :D :D :D
Roberta "Queen of the Boat Builders"
Built Zip "Oliver IV", Super Spartan "Jimmy 70", and Torpedo "The Glen L".

User avatar
BruceDow
Posts: 2132
Joined: Sat Jun 17, 2006 2:21 pm
Location: Toronto, ON, Canada
Contact:

Re: Complete!!

Postby BruceDow » Tue Sep 06, 2011 5:08 am

What a beautiful finish on that boat!
Bruce.

~~ Do what you love, and love what you do. ~~
~~ To me - only my boat is not yet perfect. Everybody else's is to be admired for I know the path they have walked (Dave Lott, 2010) ~~
Dow's Monaco Project

User avatar
vupilot
Posts: 3235
Joined: Wed Apr 15, 2009 7:36 am
Location: Indy
Contact:

Re: Complete!!

Postby vupilot » Tue Sep 06, 2011 6:53 am

Yes indeed. Great paint job and I really like the colors. Have Fun! 8)

User avatar
ttownshaw
Posts: 2337
Joined: Thu Mar 01, 2007 7:33 am
Location: Owasso, Oklahoma
Contact:

Re: Complete!!

Postby ttownshaw » Tue Sep 06, 2011 7:55 am

SWEET!
Bill

I told my wife we needed a three-car garage for my projects...she told me to ask her for permission next time before I buy a house.
http://www.unitybuild.net

User avatar
Rational Root
Posts: 653
Joined: Fri Jun 09, 2006 4:28 am
Location: Dublin, Ireland
Contact:

Re: Complete!!

Postby Rational Root » Tue Sep 06, 2011 12:21 pm

Oh Yea!

Now that's what it's all about

D
Hey! I built a boat ! No Really, I did !
http://davesboat.blogspot.com/

User avatar
BulldogBoater
Posts: 498
Joined: Wed Jan 16, 2008 9:16 pm
Location: Wilson, North Carolina
Contact:

Re: Complete!!

Postby BulldogBoater » Tue Sep 06, 2011 5:38 pm

Congrats! That's a good looking build.

KB
"I'm not trying to get it perfect. I'm trying to get it finished!"
www.tubbytug.com

denbrlr
Posts: 318
Joined: Sat Sep 18, 2010 10:06 am
Location: Peoria, IL

Re: Complete!!

Postby denbrlr » Tue Sep 06, 2011 6:17 pm

Looks great! Enjoy :)


Return to “Launching Ramp”

Who is online

Users browsing this forum: No registered users and 1 guest