3M 4200

Problems, how to use. Also see: "EPOXY", in the left-hand column of the Home page.

Moderators: Bill Edmundson, ttownshaw

Post Reply
User avatar
hoodman
Posts: 1902
Joined: Thu Nov 10, 2011 8:48 am
Location: Lafayette, IN

3M 4200

Post by hoodman » Fri Mar 30, 2018 5:00 pm

On the tube it says to use within 24 hours of opening. Do you really have to?
Matt

Building a Geronimo......!
viewtopic.php?f=2&t=25139

Soloboat
Posts: 397
Joined: Mon Mar 05, 2007 10:51 pm
Location: Orange CA

Re: 3M 4200

Post by Soloboat » Fri Mar 30, 2018 5:14 pm

If you reseal properly it is still good go go
) Champagne dreams and wishes are possible on a beer budget. Just build the boat.
Nice curves are easy on the eyes.
Go sell crazy somewhere else we're all stocked up here."As Good As It Gets" Jack Nicholson.

User avatar
hoodman
Posts: 1902
Joined: Thu Nov 10, 2011 8:48 am
Location: Lafayette, IN

Re: 3M 4200

Post by hoodman » Fri Mar 30, 2018 5:54 pm

I have one of the smaller tubes with a screw on cap.
Matt

Building a Geronimo......!
viewtopic.php?f=2&t=25139

User avatar
chugalug
Posts: 1199
Joined: Sat Nov 29, 2014 5:01 pm
Location: top of mn.

Re: 3M 4200

Post by chugalug » Fri Mar 30, 2018 6:11 pm

:D I just read about a tip in old family handyman-make loop out of bread tie and insert into the stuff leaving part sticking out so one can pull out dried up part later.just a thought-haven't tried but sound logical. :D
Working on regular-sized Bo-Jest


"If it's not crooked,It's not mine

User avatar
billy c
Posts: 2286
Joined: Sun Oct 15, 2006 7:59 pm
Location: NH
Contact:

Re: 3M 4200

Post by billy c » Fri Mar 30, 2018 6:29 pm

hoodman wrote:I have one of the smaller tubes with a screw on cap.
Make sure the tube is rolled up so the 4200 flows out the top, then put a piece of saran over the opening and put on the cap on over that. Seems to keep ok.
(insert Witty phrase here)
Billy's Belle Isle website

Post Reply