epoxy types compatibility

Problems, how to use. Also see: "EPOXY", in the left-hand column of the Home page.

Moderators: Bill Edmundson, ttownshaw

Post Reply
User avatar
Jimbob
Posts: 578
Joined: Thu Jul 25, 2013 1:07 pm
Location: Sacramento, CA

epoxy types compatibility

Post by Jimbob » Mon Nov 11, 2013 12:35 pm

New to using epoxy. Have been using poxy-grip with great success, but it has a slow cure. Any problems in using 5min epoxy when I need to use a shim on a part that is later glued up with poxy-grip?

Thanks,

Jim Neeley
Jim Neeley
Building a Barrelback in Sacramento, CA
viewtopic.php?f=15&t=28089#p172969

User avatar
jprice
Posts: 687
Joined: Sun Aug 28, 2011 11:59 am
Location: Marietta, GA

Re: epoxy types compatibility

Post by jprice » Mon Nov 11, 2013 1:09 pm

As long as the epoxy is fully cured, you should be fine. Just scuff up the surface of the cured epoxy (and wipe away amine blush if there is any) and you're good to go.

Post Reply