Glen-L.com

Well I have been sanding away at my hull trying to get ready for paint. Not sure if anyone else has noticed, but sanding kind of sucks

I still have to fill a couple of small dimples to fill, and some fillets to add to the keel strip and spray rails. I have the rest nice and smooth and fair to my eyes and hands. Only problem is that in a few areas I have sanded through to the glass (not into, just to). I have read many times here that if you reach the glass, stop and put on more epoxy, but is this necessary if I am not sanding any farther? I can't feel any difference between the areas at all.

I do not enjoy epoxying large areas (and enjoy sanding them less), but if these areas will cause problems later I will.

So my question is do I need to coat the whole thing, just around the spots where the glass is showing, or will it be OK?

Thanks for any input.

_________________
Jeremy

Hope is NOT a plan.

If your going to paint, It is not a problem. But, if you're going bright it will show.

Bill

_________________
Mini -Tug, KH Tahoe 19 & Bartender 24 - There can be no miracle recoveries without first screwing up.
Tahoe 19 Build

Well that makes sense. My arms and my back thank you sir!

_________________
Jeremy

Hope is NOT a plan.