Glen-L.com

Any suggestions on what to use to clean all the sawdust and puddy dust off the plywood before fiberglassing? I thought I had read on here that denatured alcohol was the way to go, but wanted to check before I went that route. Thanks.

I just used water. That raises the grain and closes tiny holes, then fine sand and dust off.

Bill

_________________
Mini -Tug, KH Tahoe 19 & Bartender 24 - There can be no miracle recoveries without first screwing up.
Tahoe 19 Build

In my case I used several clean, dry rags... swapped them out after they got dusty on all surfaces. A little bit of dust gets soaked out in the amount of epoxy you end up putting on the surface.

The only time I 'washed' my surface was right before I put my primer on for paint.

_________________
Ian (aka Iggy)
My Malahini Build

I blew it off with an air hose, then vacuumed the surface.

I then wiped with denatured alcohol

_________________
Boat building can best be defined as an endless series of
tragedies obscured by the occasional miracle, followed by a good bottle of beer.

Don't Dream Your Life, Live Your Dream