Seattle Barrelback progress

A forum for contacting other builders of Ken Hankinson designs. These designs are now a part of the Glen-L family.

Moderators: Bill Edmundson, billy c

neel thompson
Posts: 921
Joined: Fri Oct 01, 2010 2:33 pm
Location: Collegeville, Pa

Re: Seattle Barrelback progress

Postby neel thompson » Sun Oct 01, 2017 9:44 am

Robert, My deck planks are 2 3/4" wide, 3/8" thick with 3/16" inch spacing between planks... I used thin screws with wide washers in the space between planks to hold them down while the epoxy set. I stained the deck and then put about 8 coats of varnish on the entire deck before I caulked the joints. I used 3m 4000 UV (black) to fill in the grooves. Then after that set up, I applied about 5 more coats of vanish over the deck boards and the caulking. I did not use any fiberglass cloth anywhere above the waterline. Your boat is really looking great.... Neel
Attachments
014.JPG
002.JPG


Return to “Hankinson designs”

Who is online

Users browsing this forum: No registered users and 6 guests