Glen-L.com

The Boatbuilder Connection
It is currently Sun May 19, 2013 5:31 am

View unanswered posts | View active topics


Board index » Design » Hankinson designs

All times are UTC - 8 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
argus44
 Post subject: Barrelback 19 framing
PostPosted: Tue Aug 05, 2008 1:13 pm 
Offline

Joined: Tue Aug 05, 2008 8:10 am
Posts: 2
Location: ARIZONA
I purchased a set of plans from Glen L and after reviewing them have a question regarding the framing.
The instructions indicate the bottom frame member runs chine to chine, however the plans appear to show the vertcal running from chine to sheer. Can any one tell me which is correct.
Top
 Profile  
 
Lewis Barrett
 Post subject:
PostPosted: Tue Aug 05, 2008 2:09 pm 
Offline

Joined: Thu Aug 17, 2006 8:55 am
Posts: 239
Location: Cartersville, Ga.
On my Monaco, I believe I ran the vertical from chine to sheer. I also filled the void between the plywood gusset creating a solid joint. Probably overkill, but I just did not like having that void.

David
Top
 Profile  
 
argus44
 Post subject:
PostPosted: Wed Aug 06, 2008 9:37 am 
Offline

Joined: Tue Aug 05, 2008 8:10 am
Posts: 2
Location: ARIZONA
David Thank you for your reply.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Design » Hankinson designs

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group