Squirt with Jet Power

by Nate Brown

Page 1...

After 2 years of sitting with just the frames and battens in, I decided to finish the sheers and chine and start the skin.

Here is a shot from the rear. I added 12" to the loft and changed the angle of the transom from the outboard version.

Here I have added the bottom skin. The purple section is cut out of a Donor Seadoo watercraft. Note that I foamed in the transition from the Seadoo and the front of the boat. I dropped the keel down to the Seadoo hull section to help fair this area in. I glassed over the foamed area with biaxial cloth and epoxy resin.

The shot from the rear. Note the transition from the flat bottom to the dropped center area.

Here it is all faired in and ready to glass.