Glen-L.com

I used body filler aka bog to fill the gaps at front. Didn't turn out as well I hoped to be honest.

What do I work on next?

Thanks Jim! I stood it up so I could drill holes through the chine/sheers to the skin so I could figure where to put the screws, otherwise it was guesswork

I found a multi tool and a rasp file did a great job trimming the edges flush. The front is a bit nasty. I'll bog it up. Considering using auto wrap vinyl to waterproof it, it's small enough!

And the other side:

So... we had a kid and got busy, but finally:

And the bow:

I used the planer this side, split the transom, aargh.

Trimming the side so I can next do the bottom:

Thanks hzchevy, glad I'm not the only one

And a close-up for good measure:

Screwed the other side most of the way, trimmed it, then screwed the rest. Paint will hopefully hide the screws!

Good idea jenko, wish I had one. Ended up abusing my grinder:

Lots more screws, not quite to the front, need to trim so the left and right sides don't foul. Angle grinder?

Trimmed:

Screwed in partially: