Glen-L.com

I think I found where to get my cpes .there is some you can put on when its colder out ( down to 32) sounds promising.do you epoxy over it or do the paint way?

The jigsaw that I have- is a hand -held one. it has an adjustment on it that you can change the cut .kinda under cuts or just straight up and down. another tool is the kreg clamp. its like a visegrips but its got bigger arms?on it .Its my helping hand since I work alone.Hold a board up where I want,...

I suppose that if you don't want to cut a hole in the bottom, you could mount an aquaview camera on it and use that :DThe one I have even has infared.(Looks like I turned the lights on)

I checked the price of cpes .If I had to get 10gallons and with shipping -that's about the same as new hull.( for the ply any how . Don't know if I need thatmuch How do you apply cpes .The restor stuff they recommend using a garden sprayer and spray it on .I would rather do that if I could.Better th...

How much cpes to coat inside of standard size Bo-Jest? or do I just seal the oak. :roll:Smiths or restor-it?

I wanted to make some changes on my Bo-jest build. Raise pilothouse 9 " ,raise cabin roof a few inches ,extend windshield forward a few inches,extend roof all the way aft,lower floor cockpit to same level as pilothouse, etc. doable??

Get a good jigsaw-I have a dewalt .cost 100.bucks but its not junk .I've used a Boshe one a few years ago .Nice

Haven't done it yet . Just wanted to get input. the foam would be the two part flotation from glen-l

Any one build a tubby tug with a see thru window in the bottom? maybe when the little pirates are out boating -they can who's getting keelhauled or any thing else down there.Shivermetimbers

Picked up allthe lumber and insulation today Will start putting that in the boat shed .It won't be long,I'll be working on the boat again

I ca see the the small crane lifting the boat upside down, then the next picture it is lifted right side up .How was the turn?

Thanks ,Ill clean it completely out and try with a better hardwood pellet.Just had a thought-noticed some of the pellets were pretty long,maybe contributed to clog.

How about enclosing them in the foam.kind of a cheap filler, a Big Bubble

:( sorry I don't,but any plex would work just that the 1/4 is more spendy. I've cut 1/4 in bandsaw an even tablesaw. I get it from my local hardware store wear safety glasses !! :D some of the thin stuff is really tough-you canfold it all up without it breaking. I liked it because you can see throug...

Yah! If I sit there and babysit the stove,it runs fine but if I fill up the hopper and leave,it plugs up.starves the stove so it shuts off