Anyone have schematic for 8-pin square plug (engine) ?

Topics not covered by another category.

Moderator: Bill Edmundson

User avatar
kens
Posts: 5189
Joined: Wed Nov 12, 2003 5:25 pm
Location: Coastal Georgia

Re: Anyone have schematic for 8-pin square plug (engine) ?

Post by kens »

Yeah, I know it is a PCM. that part is easy. But, that 8-pin PCM harness I can not truly identify.
Since all the manufacturers are marinizing GM blocks, I had assumed that all the wiring was in protocol with GM/Delphi schematics.
Not so.
There is minor differences. Minor as it may be, I aint gonna hot-wire a battery to it,,,,,, not yet.
I did find a book with MEFI3/TBI/PCM. That is a big help. Actually HUGE !!
When it all boils down, you only need 1 hot-wire to awaken the ECM, everything else is peripherals.
I am not trying to do a full-function test of this thing, only trying to decifer if it is worth persueing any further.
Today I found out the block is not cracked, it does hold coolant pressure, and that is a good thing.
tomorrow maybe the oil filter for making metal
Oak..........the juice ain't worth the squeeze :D :shock: :o :)

User avatar
kens
Posts: 5189
Joined: Wed Nov 12, 2003 5:25 pm
Location: Coastal Georgia

Re: Anyone have schematic for 8-pin square plug (engine) ?

Post by kens »

TomB wrote:
Mon May 03, 2021 1:10 pm
Ken,

The label suggests a PCM engine. Maybe Vince at Discount Inboard Marine could point you in the right direction. He knows a lot about PCM. 803-345-0996

Tom
Thanks, I'll see if he can get me a service manual
Oak..........the juice ain't worth the squeeze :D :shock: :o :)

Post Reply

Return to “Miscellaneous”