Pee wee build in Sydney

[chubs]

Thanks Hz!
Bill that cartridge sounds great. Hope I can find it down here.

[chubs]

Getting the other side panel in position:

[chubs]

Screwed in partially:

[chubs]

Trimmed:

[chubs]

Lots more screws, not quite to the front, need to trim so the left and right sides don't foul. Angle grinder?

[jenko]

go for the multi tool

[chubs]

Good idea jenko, wish I had one. Ended up abusing my grinder:

[chubs]

Screwed the other side most of the way, trimmed it, then screwed the rest. Paint will hopefully hide the screws!

[chubs]

And a close-up for good measure:

[hzchevy]

Don't worry about having to use the grinder. I built LIL INSANE entirely using a grinder ( with cutting discs, sanding discs ) and a small cordless screwdriver in a gravel driveway for most of it. Money was tight and I used what I had. Turned out alright.
Good job, keep going.

[chubs]

Thanks hzchevy, glad I'm not the only one

[chubs]

Trimming the side so I can next do the bottom:

[chubs]

I used the planer this side, split the transom, aargh.

[chubs]

And the bow:

[DrBryanJ]

I used the planer this side, split the transom, aargh.

I've done that. Try to keep the blade edge moving into the plywood. I mixed some epoxy and pushed it into the split laminations. I then stapled the plys together. Came out very strong. Done have any pictures, sorry.