Let's all discuss the tools here
Moderators: BruceDow, billy c
- Posts: 1
- Joined: Wed Nov 27, 2019 8:18 am
- Location: Wilmington
I need to drill a run of 12 mm holes for lighting on my fly steps. Clearly this has the opportunity of getting messy, and splintering. What is the learned view of best way to minimise damage (apart from not doing it at all).
- Posts: 7188
- Joined: Tue Jul 31, 2007 5:23 pm
- Location: East Troy, Wisconsin
I would use the correct size Forstner bit. It will cut the cleanest hole.
Roberta "Queen of the Boat Builders"
Built Zip "Oliver IV", Super Spartan "Jimmy 70", and Torpedo "The Glen L".
- Posts: 12153
- Joined: Wed Nov 23, 2005 6:45 am
- Location: Birmingham, AL, USA
Also, tape over the cut before the cut.
Mini -Tug, KH Tahoe 19 & Bartender 24 - There can be no miracle recoveries without first screwing up.
Tahoe 19 Build
- Posts: 191
- Joined: Tue Aug 09, 2016 3:22 pm
- Location: OR
If the surface is flat ish you could also use a router with a collet and the correct sized hole. Or a 12 mm plunge bit on a plung router.