How to make square into round...?

Dinghies, day sailers, world cruisers. Many small sailboats make ideal rowboats or low-speed power boats.

Moderator: BruceDow

Post Reply
Mike Worrall
Posts: 79
Joined: Wed Jun 28, 2006 4:18 pm
Location: Los Angeles

How to make square into round...?

Post by Mike Worrall »

I'm needing to slide the round 'kranse iron' or 'eyeband' in the photo onto the last 6" or so of the square bowsprit (3.5" X 3.5" Doug Fir).

The ID of the kranse iron is 2.25", the bowsprit is 7' long.

Needing to know how to make a 'square' member into a partial 'round' member...?

I'd like to be precise, meaning I'd like to finish with a truly 'round' 2.25" on the forward 6" of the 'sprit.

Any ideas on how to go about it??


Posts: 191
Joined: Tue Aug 09, 2016 3:22 pm
Location: OR

Re: How to make square into round...?

Post by TAB »

Its not that hard. You just knock off the corners until you get it round. Start with an octagon, then turn it into a 16 side, then 32. After that its pretty easy to blend

User avatar
Posts: 877
Joined: Mon Jun 14, 2010 7:16 pm
Location: Catheys Valley, CA

Re: How to make square into round...?

Post by steveh41 »

Another approach if you have a quarter round shaper bit of the right size... ... fae9c93276
The longest journey begins with a single step… then repeat as necessary!

Post Reply

Return to “Sailboats”