cover boards

See: "Useful Information and Suppliers" for a list of lumber and plywood suppliers. Also see: "Wood & Plywood Information". Both located in the left-hand column of the Home page.

Moderator: Bill Edmundson

Post Reply
pamelalynne1
Posts: 399
Joined: Thu Jul 29, 2010 3:55 pm
Contact:

cover boards

Post by pamelalynne1 »

What is the recommended thickness for cover boards over a plywood deck?

JimmY
Posts: 961
Joined: Sat Jul 30, 2016 11:08 am
Location: Brighton, MI

Re: cover boards

Post by JimmY »

Depends on if you are expecting them to add strength over the plywood alone or not.

On my Squirt, they are 3/16" over1/4" plywood.
-Jim
Nothing says poor craftsmanship like wrinkles in your duct tape!

User avatar
Roberta
Posts: 6554
Joined: Tue Jul 31, 2007 5:23 pm
Location: East Troy, Wisconsin

Re: cover boards

Post by Roberta »

On my Torpedo, I planed my deck and cover boards to just under 3/8". This was over 1/4" plywood. Some builders like to emulate the old Chris Craft boats with the really thick cover boards that have a big radius to the sides. This needs some pre planning during the build.

Roberta
Roberta "Queen of the Boat Builders"
Built Zip "Oliver IV", Super Spartan "Jimmy 70", and Torpedo "The Glen L".

Hercdrvr
Posts: 1093
Joined: Mon May 11, 2015 12:52 pm
Location: McKinney TX

Re: cover boards

Post by Hercdrvr »

What boat design are we talking about?
For me, 3/8” thick works well over 1/4” plywood sub deck because it’s a good use of material. 4/4 stock re-sawn and run through planner yields about 3/8”.
3/8” leaves me enough material to sand out any low spots in the deck. Structurally there is no need for more than 1/2” total thickness if deck battens are built to the plans.
Matt B

Post Reply

Return to “Wood and Plywood”