How to make square into round...?

See: "Useful Information and Suppliers" for a list of lumber and plywood suppliers. Also see: "Wood & Plywood Information". Both located in the left-hand column of the Home page.

Moderator: Bill Edmundson

Post Reply
Mike Worrall
Posts: 79
Joined: Wed Jun 28, 2006 4:18 pm
Location: Los Angeles

How to make square into round...?

Post by Mike Worrall »

I'm needing to slide the round 'kranse iron' or 'eyeband' in the photo onto the last 6" or so of the square bowsprit (3.5" X 3.5" Doug Fir).

The ID of the kranse iron is 2.25", the bowsprit is 7' long.

Needing to know how to make a 'square' member into a partial 'round' member...?

I'd like to be precise, meaning I'd like to finish with a truly 'round' 2.25" on the forward 6" of the 'sprit.

Any ideas on how to go about it??

MW
G-L Francis Drake / C-Flex
Sprit.jpg
Bowsprit.jpg

Post Reply

Return to “Wood and Plywood”