Escapade

#792 a 26' flying bridge cabin cruiser Build in PLYWOOD


flying bridge cruiser plans



Characteristics
Length overall 26'-2"
Length waterline 22'-0"
Beam 10'-0"
Hull draft 19"
Displacement 6050 lbs.
Hull weight (approx.) 1400 lbs.
Hull depth 5'-2"
Freeboard forward 3'-11"
Freeboard aft 3'-0"
Headroom 6'-3"
Cockpit size 10'-3" x 8'-0"
Fuel capacity 100 gals.
Fresh water capacity 30 gals.
Sleeping accommodations 4
Hull type: High speed planing hull with full length modified deep vee. Compound bottom with bulbous section at the keel and reverse curve at the chine. Designed for double diagonal plywood planking on the bottom and sheet plywood on the sides.
Power: Inboard marine engine, gasoline or diesel, with appropriate reduction gears, usually 1 1/2: 1 or 2:1. Engine may be centrally located with conventional drive or stern mounted with either vee drive or outdrive unit. Engine weight not to exceed 1100 lbs. for stern mounted installation. Twin screws may be used, centrally mounted with addition of motor box in the cockpit.
Can the hull be extended or shortened? Yes. Up to 10% by re-spacing the frames from the aft end of the stem to the transom a proportional amount. We do not recommend increasing the beam.

Photographs Bill of Materials Notes Return


Glen-L marine designs / www.glen-l.com / Boat plans for the home builder